Project

Servo Angle LCD screen Push the joystick

December 23, 2015

4867

Introduction

Hi Friends, we provide in terms of servo motors manually using the joystick at the same time we do a project today we can see the LCD screen. Previously made servo motor control with the joystick and LCD display for our benefit, you will now be able to see very well what it was.

Used materials:

Arduino UNO R3
Joystick
10K pot
Servo-motor
Breadboard
Cables

Circuit Diagram

Program Code

# Include <liquidcrystal.h>
# Include  <Servo.h>
Lcd liquidcrystal (12,11,5,4,3,2);
// LCD RS = 12 - 11 = ENABLE - D7 = 5, D6 = 4, D5 = 3, D4 = 2 - R / W = GND
const  int servo1 = 13; // No. 5 pin digital servo 1
const  int yonx = 3; // left and right analogue 3
inter servodeg;
Power servomotor1;
void setup () {
lcd.beg of (16.2); // defined health 2x16 LCD and use the LCD.
// Servo-motor
servomotor1.attach (servo1);
}
void loop () {
servodeg R = analogread (yonx); // read the joystick in the value we put into our variable.
servodeg R = map (servodeg is 0, 1023, 0, 180); // 0-180 degrees rotation
servomotor1.writ (ER servodeg);
delay (15);
lcd.setcurs is (0,0); // we are launching the first corner of the LCD cursor to the left and we print our article.
LCDs. print ("Power Rating");
LCDs. print (servodeg is); // convert our command, we press the screen with the map command.
lcd.setcurs is (0,1); // 2. We bring the cursor line and we print our article.
LCDs. print ("engineers gallery");
delay (500);
lcd.cle is (); Clearing // screen.
}
 